English
LD-G-2
Page 20
Setting the locomotive address and the functions
1. Setting the locomotive address
You are in the menu point „Setting the locomotive address“ when all
lighting connected to the function outputs flash regularly. Enter the
desired address. You do not need to enter the old address. Confirm
your setting by switching the function key „function” on and off once.
After the taking-over of the locomotive address the regular flashing of
the connected lighting stops and the decoder proceeds immediately to
the programming of the first function output.
2. Setting the function outputs
Now the function outputs X4, X3, X1 and X2 are programmed one after
the other. The function keys are assigned in succession, and the
dimming and the kick function are set for each output.
Assigning the function keys:
While the programm continuously
switches the ouput to be programmed on and off (and the lighting
connected to the output flashes) switch on the functions key(s) F1 to
F4 on your central unit with which you want to switch on the output in
later operation. You can assign several function keys to one output of
the decoder. Please notice that in operation the acceleration and brake
delay is switched via F3 and the second velocity characteristic is
activated via F4. If you do not want to the function output in operation
via „function“ set the speed level to “0”.
If you want to switch the function output in operation via „function“ you
have to make the following settings:
Speed level 1 : Output will be switched on during backwards motion.
Speed level 2 : Output will be switched on during forward motion.
Speed level 3 : Output will be switched on independent of the direction
of motion.
Advice: On the Märklin* Central Unit 6021 the speed levels 1,2 and 3
correspond to the settings 20, 40 and 60.
Confirm your settings by switching the function key „function“ on and
off once.