- 2 -
Note: you cannot interchange the upper and lower rods. Follow the color code. Orange with
Orange color for top rolls and Blue to Blue for bottom rolls.
THREADING THE FILM
Read the threading card supplied with each roll of film carefully. Do not mistake the stabilizer bar for
the idler roller.
1. To thread the film through the “hot rollers” & “pull rollers”, please pull the handle to the “UP”
position to
separate upper & lower hot rollers. User can slide down the lower idler bar along the
slot for easier installation.
2.
Thread the film by
the rollers and make sure the film is perfectly aligned at the top and bottom
Note: Overlap will cause the top film to deposit adhesive on the hot rollers and pull rollers, so this
procedure is critical.
3. Make sure the film is correctly threaded based on the threading guide.
ADJUSTING THE FILM TENSION
The top and bottom supply rolls should have about the same tension. By turning the top roll with one
hand and the bottom roll with the other, it can be determined if one of the rolls is tighter than the
other. Also, if the tension is not equal between the top and bottom rolls, the laminated product will