- 1 -
1 IMPORTANT SAFEGUARDS
When using electrical machines, basic precautions should always be followed to reduce the risk of
electric shock and injury to people, including the following:
1.
Read all instructions.
2.
Always unplug the machine when not in use or before cleaning.
3.
Do not use outdoors.
4.
Extreme caution should be taken when the machine is used by or near children or disabled persons.
5.
To protect against risk of electrical hazards, do not immerse cord, plugs, or the whole machine in
water or other liquids.
6.
Do not operate the machine with a damaged cord or plug, or after the machine malfunctions, has
been dropped or is damaged in any manner. Return the machine to the nearest authorized service
facility for examination, repair, or adjustment.
7.
Do not use accessory attachments not recommended or sold by the machine’s manufacturer.
8.
Do not let the cord touch hot surfaces or hang over the edge of the work table.
9.
Do not use the machine for other than its intended use. This machine is intended for Office or
Household use only.
10.
The socket outlet shall be near the machine and shall be easily accessible.
11.
Warning-hazardous moving parts-keep fingers and other body parts away.
2 LOCATION
1. Please remove the laminator carefully from its packaging and place it on a flat work surface. Place
the machine in an area where it will normally be used, ensuring adequate room for the finished
laminate to flow or slide out at the back.
2. Please install the shield and feed tray at the correct positions until the two LED lights on the left
side panel turn off, otherwise the machine will not feed the film.
3 MACHINE OPERATION
A. LAMINATING FUNCTION
(1) TWO-SIDED LAMINATION
LOADING THE FILM
This machine has the capability of loading laminating film with 1” cores or with 3” cores using the
included core adapters. Unpack the upper and lower rods. Remove the feed tray. Load the film onto
the rods by turning the top rod clockwise and the bottom rod counter- clockwise as you push the
rods through. Make sure to leave equal lengths of rod out of each end using the guide marks to
correctly position the roll of film. Load the rods on the laminator. When using the adapters for film
with 3” cores, follow an adapter---film----adapter sequence onto the rod and fit the adapters onto the
paper core.