Tamas Hydronic Systems Inc.
Page 15
Tamas Hydronic Systems
Drill 5mm hole through
center of end cap
1
Insert Purge Valve into
end cap port, secure with
valve clip.
2
Sensor fittings can also be
installed. Drill out 5mm (0.2”) hole in
bottom of fitting before installation.
Insert Purge Valve into
Z-Block port
(part #025-0014)
1
Push Valve Clip into Z-Block
to secure the Valve
(part #025-0015)
2
1.
Insert the purge valve until it
reaches the end stop in the
Z-Block
2.
Once the purge valve fitting
is fully seated, slide the
fitting clip into the groove in
the port, securing the fitting
to the block.
Purge/Drain Valve Installation
Purge/Drain Valve Installation in End Cap
Depending on the orientation of the Z-Block distribution manifold, the purge
valve can be installed in one of the end caps. To do this, drill a 5 mm (02”) hole
through the center opening on the end cap, and insert the purge valve. Once
the purge valve fitting is fully seated, slide the fitting clip into the groove in the
port, securing the fitting to the block.
Assembly
