Settings
Quick start guide
26
Settings
This section describes how to set the tear position, the first printing line, the print
head gap as well as the font selection and the character density.
Setting the tear position
If the tear position of the paper is not aligned with the tear edge of the top cover of
the printer, you can adjust it. Inserted paper needs to be torn off if necessary and
retracted to park position.
Press the
Setup
key. The printer changes to setup mode.
Press the
Adjust
(2) key.
Press the
Tear
(4) key.
Swing the soundproofing cover towards the front (see “Printer at a glance”,
page 5). The tear edge is located at the front side of the paper output opening.
Press the
<
(2) or
>
(3) key to move the perforation to the desired position. Con-
firm the input by pressing the
Set
(1) key.
Confirm the input again by pressing the
Setup
key. The printer is reset to the initial
status.
The correction made – a maximum of approx. 1" (2.5 cm) in each direction – will
be retained after switching the printer off. It can be set separately for each paper
path.
Adjust
Paprpath
Menu
Char
Online
Setup
2
1
3
4
TOF
Head
Tear
Online
Setup
2
1
3
4
TearAdj= 00/72"*
Set
<
>
Exit
Online
Setup
2
1
3
4
Quick Start-en.fm Seite 26 Donnerstag, 17. Juni 2004 9:36 09
