TallyGenicom 2440, Руководство пользователя

Страница: 87 / 150

Troubleshooting Solving problems
6-3
The top margin is wrong. The top margin is the sum of the printer’s top-of-
form setting, the software-specified top margin,
and the printer’s TOP-MARGIN setting. Proceed
as follows:
•
Make sure that the top-of-form setting is correct.
The factory default is 0 mm (0 inch).
•
Check the software-specified top margin. Refer
to your software documentation.
•
Check the printer’s TOP-MARGIN setting. See
the section
“COMMON (PUSH TRAC) menu” or
“FRICTION menu” in Chapter 4, “Special mode” .
Lines are double spaced instead
of single spaced. Change the CR CODE setting in the printer Set-
Up mode to CR=LF+CR. See
“SET-UP menu” in
Chapter 4, “Special mode” .
The printer overprints on the
same line. Change the CR CODE setting in the printer Set-
Up mode to CR=LF+CR. See
“SET-UP menu” in
Chapter 4, “Special mode” .
The next print line starts where
the previous line ended instead
of at the left margin. Change the CR CODE setting in the printer Set-
Up mode to LF=LF+CR. See
“SET-UP menu” in
Chapter 4, “Special mode” .
The printer overprints on the
same line while the next print
line starts where the previous
line ended instead of at the left
margin. Change the CR CODE setting in the printer Set-
Up mode to CR=LF+CR and LF=LF+CR. See
“SET-UP menu” in Chapter 4, “Special mode” .
Problem Solution