6
Chapter 2, Installing the NIC
Preparing the Printer
1.
Turn off the printer
(A)
.
2.
Remove the power cord from the back of the printer,
disconnect the printer cables from the ports
(B,C)
.
Position the printer so you are facing the side and back
corner where the cable port is located. Make sure you
have enough room to work.
3.
Remove the two screws from the side cover
(D)
.
4.
Slide the side cover approximately
3
⁄
4
inch towards the
back of printer
(E)
using the handle on the side cover.
Making sure the wire-snaps on the parallel port are not in
the way, rotate the side cover away from the printer
approximately
1
⁄
4
inch.
5.
Lift the side cover off the printer
(F)
. If you are going to
connect to a Macintosh, install the PostScript SIMM and
8MB SIMM included in your Network upgrade Kit. See
the instructions included in the kit or consult the
Xpress
T9412i User’s Guide
.
WARNING!
Avoid touching the controller board
circuitry and components.
A
B
C
D
E
F
Содержание XPRESS T9412i
