WEBS-ZPS Zone Paging System Instructions
Copyright © 2011 Talk-A-Phone Co. All rights reserved.
Talk-A-Phone
Co.
• 7530 North Natchez Avenue • Niles, Illinois 60714-3804
Page 7 of 7
Phone 773.539.1100 • Fax 773.539.1241 • [email protected] • www.talkaphone.com
All prices and specifications are subject to change without notice.
Talk-A-Phone, Talk-A-Lert, Scream Alert and WEBS are registered trademarks of Talk-A-Phone Co.
VI.
Zone Paging System Operation
Make sure the PROGRAM/RUN switch is in RUN position.
To Page a Zone
1. Dial the paging access number for your telephone system.
2. Listen for the confirmation tone (i.e. a double beep).
3. Dial the number of the zone you wish to page. All dialing must be two digits. For example:
[0][1]
for zone 1 (Zone A of the first zone module)
[0][2]
for zone 2, etc.
If a zone number does not exist, the caller will hear a busy tone.
4. Make the page. Hang up when finished.
To Make an All-Call Page
1. Dial the paging access number for your telephone system.
2. Listen for the confirmation tone (i.e. a double beep).
3. Dial
[0][0]
and make an All-Call page.
4. Make the page. Hang up when finished.
To Page a Zone Group
1. Dial the paging access number for your telephone system.
2. Listen for the confirmation tone (i.e. a double beep).
3. Dial
[*]
and the zone group number you wish to page. Zone group numbers consist of two digits.
[*][0][1]
for zone group 1,
[*][0][1]
for zone group 2, etc. up to 32 zones.
4. Make the page. Hang up when finished.
