WEBS-PM
–
Pedestal Mount
Emergency Phone Station with WEBS
®
Installation Instructions
Copyright 2014 Talk-A-Phone Co.
• 7530 North Natchez Avenue • Niles, Illinois 60714 • Phone 773.539.1100 • [email protected] • www.talkaphone.com.
All prices and specifications are subject to change without notice. Talk-A-Phone, Scream Alert, WEBS and WEBS Contact are registered trademarks of Talk-A-Phone Co. All rights reserved.
Page 2 of 4
4.
Install one 3/4” nut and one washer on each anchor bolt 2.5”
-3.5" above grade to top of washer. This
will allow for a
1/2" air gap
between the foundation and the Pedestal which will allow airflow and
prevent moisture problems. Verify that the nuts are level (0° pitch).
NOTE:
To insure proper grounding of all electrical components, the tower mount should be effectively earth
grounded from the grounding stud (located across from the lower access panel) with 6 AWG or better insulated,
stranded copper wire to the metallic power service raceway (conduit) or an 8' or longer corrosion-resistant ground
spike.
5. After removing the lower access panel of the Pedestal, install the tower onto the bolts with the
Emergency Phone opening oriented in the desired direction. Install second set of nuts and washers.
Tighten the upper nuts; the bottom set is used only for leveling.
