ETP-500
Series Analog Call Station
Installation & Operation Manual
Page
7
of
23
Rev. 3/16/2017
Copyright 2017 Talkaphone
• 7530 North Natchez Avenue • Niles, Illinois 60714 • Phone 773.539.1100 • [email protected] • www.talkaphone.com.
All prices and specifications are subject to change without notice. Talk-A-Phone, Talkaphone, Scream Alert, WEBS and WEBS Contact are registered trademarks of Talkaphone All rights reserved.
Speaker and Microphone Codes
The speaker and microphone turn on automatically when the unit is activated. The caller will hear dial
tone, dialing, and busy signals. You may wish to silence these call progress tones. You may also wish
to activate the silent call in feature by activating the speaker and microphone when
you
call the
unit
.
Command
Function
*5*
Turns on unit speaker & microphone when you call in to the unit. Effective for
that call only.
*78*
Automatically turns on unit speaker & microphone every time you call in to the
unit.
*79*
Cancels the *78* command
(default)
*19*
Makes call progress tones audible
(default)
*20*
Makes call progress tones silent (Mode I only)
If *78* has been programmed, future calls to the unit will begin in communication mode. To perform
any programming, hold the * button down for a full second prior to entering the guard code. If the
phone you are calling from cannot play a tone for 1 second (e.g. a cell phone), you may need to call
from a different phone.
Intelli-Voice Codes
Intelli-Voice allows you to record a voice message that will play automatically
when the guard answers
the call
. This message serves to identify the unit to the guard station.
Command Function
*72*
Set the message length to 5 seconds
*73*
Set the message length to 10 seconds
(default)
*74*
Set the message length to 16 seconds
*58*
Record the identification message after the beep and until the next beep
*59*
Playback the recorded message
*77*
Disable the automatic playback of the recorded message when a call is
answered and
delete the message
*70*
Disable automatic playback of the recorded message when a call is
answered, but
do not delete the message
*71*
Enable the automatic playback of the recorded message when a call is
answered
(default)
*84*
Activate the message when pressing Button #1 only
(default)
*85*
Activate the message when pressing Button #2 only
*86*
Activate the message when pressing either Button #1 or Button #2
Phone ID Codes
An important function of the phone is the ability to identify itself and its location to the guard station,
because the caller may be unable to do so. There are several methods of accomplishing this task.
One method is to have the phone transmit a DTMF identification number when the call is answered.
This DTMF transmission can be received by the Talk-A-
Lert™ software
(model ETP-TAL).
The code is 6-digits long and any leading digits you do not enter will automatically be 0. For
example, if you enter a code of 23, it will be transmitted as 000023.
You should use codes that are logical for your environment. For example, if you want to identify the
third elevator in the second elevator bank of the fifth building on campus, you might use the code
050203.
