VOIP-500
Series Phone
Quick Installation Guide
Page
6
of
6
Rev. 2/4/14
Copyright 2012 Talk-A-Phone Co.
• 7530 North Natchez Avenue • Niles, Illinois 60714 • Phone 773.539.1100 • [email protected] • www.talkaphone.com.
All prices and specifications are subject to change without notice. Talk-A-Phone, Scream Alert, WEBS and WEBS Contact are registered trademarks of Talk-A-Phone Co. All rights reserved.
X. Line Level Audio
Connect the Line Level Audio connector on the PCB as shown in the
Figure 2
, to the respective device
on the other end, such as the WEBS
®
paging amplifier, recording device, speaker, etc.
XI. Final Assembly
After completing the field wiring installation, fasten the back box on to the faceplate with the six (6)
hardware nuts and washers.
NOTE:
It is the installer’s obligation to ensure that the wiring should pass through the cable entry hole
at the bottom of the back box. Please exercise caution when reinstalling the back box and ensure that
no cables are crushed during the process.
Install the
VOIP-500 Series Phone
into its appropriate mount (e.g.
ETP-SM
, as shown in
Figure 7
),
with the six (6) tamper resistant #10 faceplate screws provided.
Figure 7
- Installation of VOIP-500K into an ETP-SM
