`TALEX Spółka z ograniczoną odpowiedzialnością
ul. Dworcowa 9c, 77-141 Borzytuchom
tel. (59) 821 13 40
e-mail.:
21
6.1 Proper installation of the sweeper
The working height of the brush is adjusted manually with the support stands. Depending on
the amount of dirt, the pressure can be set individually. The pressure is set by rotating the cranks.
Note the position of the side cover markers relative to the bucket so that both sides are in the same
position (Drawing 7a. Brush Pressure Adjustment). The brush bristles should be about 2 cm pressed
against the substrate, however, the pressure depends on the degree of surface contamination and is
set individually.
When lowering the brush, the device should be in the working position (Drawing 7a. Brush Pressure
Adjustment). However, if you want to raise the brush up, lift the sweeper-bucket so that the support
stand has no contact with the ground (spoon) (Drawing 7b. Adjusting the brush pressure), only in this
position you should raise the brush.
Adjusting the brush upwards in the machine working position may damage the
support stand.
Drawing 7a. Brush pressure adjustment
- downward adjustment of the brush.
