TALEX Sp. Z O.O. Sp.K.
ul. Dworcowa 9C
77-141 Borzytuchom
tel. (59) 821 13 26.
English mob.: +48 507 828 310
e-mail.
www.talex-sj.pl
User Manual
FastCUT 300 Disc Mower
Page
11
of
56
•
Using a damaged or incomplete jointed telescopic shaft is prohibited. In particular, it is
strongly forbidden to work without guards on moving parts.
•
The telescopic shaft end to be connected to the tractor is marked appropriately, but
before starting operation make sure that the direction of the shaft rotation is correct.
•
Never leave the vehicle unattended when the engine is running. Before leaving the
driver's seat (the cab), lower the machine to the ground, turn off the engine of the
vehicle, remove the ignition key, and apply the handbrake.
•
Avoid wearing unbuttoned, hanging parts of work clothes during the operation,
assembly, disassembly or adjustment. Keep them away from any machine parts which
are likely to catch them.
•
After work, preferably clean and wash the mower in a wash providing sewage treatment
or a settling tank for waste water neutralisation.
•
The machine should be kept and stored an on a flat, hardened surface, under a
protective canopy in places protected from unauthorized access of persons and animals,
thus eliminating the risk of accidental injuries.
•
In case of failure, immediately turn off the drive transmitted from the vehicle.
•
When working with the mower, use hearing protection headphones to minimize your exposure
to noise.
In addition, it is recommended to close the doors and windows of the vehicle’s
cab.
Failure to observe the above guidelines may be hazardous to the operator and
other persons, as well as damage the mower. The operator is responsible for any
damage caused by failure to adhere to the above rules.
