TALEX Sp. Z O.O. Sp.K.
ul. Dworcowa 9C
77-141 Borzytuchom
tel. (59) 821 13 26.
English mob.: +48 507 828 310
e-mail.
www.talex-sj.pl
User Manual
FastCUT 300 Disc Mower
Page
10
of
56
•
Secure the hitch assembly (three-point hitch) of the mower only by means of typical
cotter pins. Do not use other securing methods.
•
Follow the procedure laid out in Chapter 6 to carry out inspections of the condition and
completeness of the machine cutting tools with regard to their natural wear. Operation
and maintenance
•
After mower receipt and transport, make sure that the machine is not damaged and
check its technical condition.
•
Standing under the raised mower is not allowed to prevent being crushed by the
components of the machine.
•
When adjusting, keep your fingers and limbs away from the structural parts of the
machine.
•
Leaving the tractor cab when its engine is running and before all the rotating parts have
stopped is not allowed.
•
The operator of the vehicle coupled with the mower must ensure that no person
can
approach the machine during its operation within the distance of 50m from the
running
mower.
•
Before switching on the mower’s drive, lower the cutting unit to its service position.
•
Mowing may be started only after the PTO reaches its nominal speed of 1,000 rpm. Do
not overload the PTO shaft or the mower, and engage the clutch gently.
•
Ensure suitable visibility when u-turning, reversing or manoeuvring the machine, or
ensure assistance from a properly trained person.
•
Mowing during reversing the vehicle is not allowed.
When reversing, the machine must
be raised.
•
When connecting the hydraulic lines, make sure that the hydraulic system is not under
pressure.
•
The machine may only be connected to the tractor by means of a telescopic PTO shaft
selected by the manufacturer.
•
It is forbidden to stand between the vehicle and the mower, while the vehicle’s engine is
running.
•
Working on slopes exceeding 8% is not allowed.
•
Exercise particular caution when working on slopes.
•
When driving around curves and turning, switch off the PTO drive
•
It is forbidden to operate the machine in close proximity of public squares (parks,
schools, etc.) or on stony grounds, to prevent the risk of stones and other objects being
thrown into the air.
•
Do not allow the PTO service speed to exceed 1,000 rpm, while the driving speed must
be adjusted according to the type of work being done.
