4- Divide the hair in the middle in two half
sections. Clip away one half section from the
back towards the front, to keep it out of the way
while treating the other side. (Hair Clip Not
Included) Repeat it on the opposite side after
treating the first half section. Now you are ready
to begin treatment.
Step 1.
Select a small, "THIN" section
of hair. Spread it to a "THIN" layer before placing
it on top of the hair plate GUIDES and comb it
"FREE OF TANGLES". This will allow the hairs
to freely run through the hair plate and avoid
getting pulled.
Step 2.
Open the hair plate by sliding the Lock
ON to the Lock OFF position located underneath
the unit. (See Fig. 2)
Step 3.
Select the ARROW pointing to the floor
and press the button. A green light will turn ON
letting you know that the unit is activated and
ready to go. Hint! The motor will only turn ON
when pressing the Pressing Handle. Remember,
the Directional Switch is reversible, so as you
switch from one hand to another, you also need
to reverse the directional switch always with the
ARROW pointing to the floor. (See Fig. 3)
Step 4.
Place the "THIN" section of hair on top
of the hair plate CENTER GUIDES (See Fig. 4),
no wider than the width of the center guides &
no thicker than the height of the center guides.
Step 5.
Gently squeeze the hair plate Pressing
CLIP AWAY ONE SIDE
BEGIN TREATMENT
Fig. 1
Fig. 2
Fig. 3
Fig. 4
8
