TAKIMA tools TKBG-150, Инструкция по эксплуатации

Страница: 11 / 16

0
6. Operation
6.1 ON/OFF switch (1)
To switch on the equipment set the On/Off
switch
() to position .
Move the ON/OFF switch (1) to position 0 to
switch off the equipment.
After switching on the equipment wait for the
equipment to reach its maximum speed of
rotation before commencing with the sanding/
grinding work.
6.2 Grinding
• We recommend that you use the fine-grained
grinding wheel for fine sanding/grinding work
and the coarse-grained grinding wheel for
coarse sanding/grinding work.
• Place the workpiece onto the workpiece
support (7) and slowly guide the workpiece
towards the grinding wheel (5) at the desired
angle to the point where workpiece and
grinding wheel make contact.
• Move the workspiece slightly back and forth
to produce an optimal grinding result. This way
the grinding wheel (5) is evenly worn. Allow the
workpiece cool every now and then.
Important!
If the grinding wheel becomes jammed during
operation, remove the workpiece and wait until
the tool reaches its top speed again.
7. Replacing the power cable
If the power cable for this equipment is
damaged, it must be replaced by the
manufacturer or its after-sales service or
similarly trained personnel to avoid danger.
8. Cleaning, maintenance and ordering of
spare parts
Always pull out the mains power plug before
starting any cleaning work.
8.1 Cleaning
• Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it with compressed air at low
pressure.
• We recommend that you clean the device
immediately each time you have finished using
it.
• Clean the equipment regularly with a moist
cloth and some soft soap. Do not use cleaning
agents or solvents; these could attack the
plastic parts of the equipment. Ensure that no
water can seep into the device. The ingress of
water into an electric tool increases the risk of
an electric shock.
8.2 Maintenance
There are no parts inside the equipment which
require additional maintenance.
8.3 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
• Type of machine
• Article number of the machine
• Identification number of the machine
• Replacement part number of the part required
9. Disposal and recycling
The equipment is supplied in packaging to
prevent it from being damaged in transit. The
raw materials in this packaging can be reused