TAKIMA tools TKBG-150, Инструкция по эксплуатации

Страница: 10 / 16

9
plastics and other materials using a selection
of grinding wheels.
The machine must only be used for its intended
purpose! Even if the machine is used as
intended, certain residual risk factors cannot be
completely eliminated. The following hazards
may arise in connection with the machine’s
construction and layout:
• Contact with the grinding wheel where it is not
covered.
• Catapulting of parts from damaged grinding
wheels.
• Catapulting of workpieces and parts of
workpieces from the machine.
• Damage to hearing if ear-muffs are not used
as necessary.
The equipment is to be used only for its
prescribed purpose. Any other use is deemed
to be a case of misuse. The user / operator
and not the manufacturer will be liable for any
damage or injuries of any kind caused as a
result of this.
Please note that our equipment has not been
designed for use in commercial, trade or
industrial applications. Our warranty will be
voided if the machine is used in commercial,
trade or industrial businesses or for equivalent
purposes.
5.1 Fitting the spark refl ector
(Fig. 2-4 / Item 3)
Fit the spark refl ector (3) to the double wheel
grinder/sander using the adjusting screw (10).
5.2 Adjusting the spark refl ector
(Fig. 5 / Item 3)
• Adjust the spark deflector (3) using the
adjusting screw (0) so that the distance
between the dry grinding wheel (5) and the
spark deflector (3) is as small as possible and
certainly does not exceed 2 mm.
• Adjust the spark deflector (3) periodically to
compensate for wear on the wheel.
5.3 Fitting the workpiece supports
(Fig. 6 / Item 7)
Undo the fastening screws (6). Secure the
workpiece supports (7) to the double wheel
grinder/sander using the fastening screws (6).
5.4 Adjusting the workpiece supports
(Fig. 7 / Item 7)
• Adjust the workpiece supports (7) using
the fastening screws (6) so that the distance
between the dry grinding wheel (5) and the
workpiece support (7) is as small as possible
and certainly does not exceed 2 mm.
• Adjust the workpiece supports (7) periodically
to compensate for wear on the dry grinding
wheel.
5.5 Changing the grinding wheel (Figs. 8-9)
Remove the 3 screws (A) holding the side
section of the safety hood (B) and remove the
safety hood. Undo the nut (D)
(Important: The
left grinding wheel is fastened with a left-
handed thread and the right grinding wheel
with a right-handed thread),
by holding
the nut of the grinding wheel mount on the
opposite side. Remove the fl ange (C). and
replace the grinding wheel (5). The grinding
wheel is mounted with the help of a rag. Mount
the fl ange (C) on the shaft and screw on the
nut (D) hand-tight. To tighten the nut (D), hold
the grinding wheel (5) with a rag and tighten
the nut (D).