4-1
INSTALLATION METHOD
4
5-1
INITIAL SETTING
5
In order to avoid cross talk between the same channel, select the different timing setting A or B.
MODULATION FREQUENCY CHANGEOVER
Master : Output the synchronized signal from synchronized output terminal.
Slave : Transmitter irradiate a beam as setting channel and setting timing according to synchronized input signal from master.
1 2
1 2
1 2
1 2
1 2
4 CH
2 CH
3 CH
1 CH
Factory set : 1CH
* In case of 2 level installation, set the same channel
and change the synchronized timing.
* In case of more than 3 level installtion, change the
channel but not neighboring number.
* Set the transmitter and the receiver to the same channel.
Panhead screw
(M3×12mm)
: 4 pcs
(ACCESSORIES)
Housing
(Frame)
* Installed on the transmitter and the receiver
INSTALLATION INTO HOUSING
5-2
* Installed on the transmitter and the receiver
5-3
* Only installed on the transmitter (Receiver to be slave only)
3
3
3
A
B
Factory set : A
* Set the same timing for same transmitter, receiver pair.
* In case add one more set in same synchronized wire group,
Please set the different timing.
4
4
4
Master Slave
Factory set : Master
* Select only one transmitter as Master and others as Slave
* One master for up to 7 slaves (Transmitter : 3, Receiver : 4) in one synchronized
wire group.
Read the instruction manual for your housing carefully, and install the product into the housing correctly.
Wiring is required based on the sensor installation.
Refer to "6 WIRING METHOD" for wiring and connection.
Refer to "9 EXPLANATION OF FUNCTIONS" for switching channels and transmitting beam power.
MASTER/SLAVE SELECTION
SYNCHRONIZED TIMING
9
