Takeuchi TB23R, Руководство оператора

Страница: 95 / 190

93
MAINTENANCE
General
Do not clean parts with fuel.
Do not use fuel to clean parts. Use a non-
combustible cleaning agent.
Keep dirt out.
When mounting and removing parts, do so
in a place where there is no dust, clean the
working area and the part, and keep dirt
out.
Clean mounting surfaces.
When mounting and removing parts, be
sure that the surfaces of contact of the
parts are clean. If the sealing grooves of the
surface of contact are damaged, consult a
Takeuchi sales or service outlet.
Seals and split pins
�
Replace removed seals and split pins
with new ones.
�
When mounting, be careful not to
damage or twist the seal.
Sealing tape
�
When wrapping sealing tape around
plugs, etc., remove any old sealing tape
from the threads and clean the threads.
�
Wrap the sealing tape tight, leaving 1 or
2 threads at the tip free.
Disposing of wastes
�
Collect spent fluids from the machine
in containers. Disposing of wastes
irresponsibly damages the environment.
�
Dispose of oil, fuel, cooling water,
coolant, filters, batteries and other
harmful substances as prescribed by
law.
Check after maintenance
�
Gradually increase the engine speed
from a low idle to maximum speed and
check that there is no oil or water leaking
from serviced parts.
�
Operate all the operating levers and
check that the machine is operating
properly.
Cautions on handling of battery cables
�
Disconnect the battery cables (+,–) before
working on the electrical system or doing
any welding.
Remove the negative (–) battery cable
first.
When reconnecting the battery, connect
the negative (–) battery cable last.
�
Do not disconnect the battery cables
while the engine is running. Doing so
could damage the electronic circuitry of
the alternator and other parts.
E4G001
Sealing tape
Leave 1 or 2 threads free