TAKASAGO HX-S-G2 Series, Инструкция по эксплуатации

Страница: 63 / 240

Useful Function
63
④
HX-S-G2 series is designed not to perform OUPUT ON for 1 sec. after OUTPUT OFF.
Therefore, please set 0V or 0A for "STEP" ,without setting control contents as "OUTPUT OFF",
when it requires 0V and 0A output from 0.1 sec. to 1 sec. for min.control time of sequential operation function.
Step1
STEP control
Step 2
OUT OFF control
Step 3
STEP control
It takes 1.0 sec. to
become able to perform
OUT ON once OUT OFF
is set.
Control time
：
0.1s
(V
o
lta
g
e
/C
u
rr
e
n
t)
(Elapsed time)
Control time
：
0.1s
Control time
：
0.1s
Waveform after setting step2 as OUTPUT OFF
Step 1
0.1s 0.1s 0.1s
STEP control
Step 2
STEP control
Step 3
STEP control
Preset CV value 0V
Preset CC value 0A
Please set the value as shown on
the left to set less than 1 sec.
such as 0V and 0A.
(V
o
lt
a
g
e
/C
u
rr
e
n
t)
(Elapsed
time)
Waveform after setting step2 as STEP control
⑤
It is unable to use sequential operation function, variable threw-rate function (available with F option),
and sequential On/OFF function (available with F option) at the same time. The setting for Startup Mode
selection will be changed forcibly as follows.
◎
In case of variable threw-rate enabled
- FUNCTION Item 1 = 3: CV Threw-rate → 2: CV Priority (Low-speed)
7: CC Threw-rate → 2: CC Priority (low-speed)
◎
In case of variable sequential ON/OFF function enabled
- FUNCTION Item 7 = ON delay time = 0.00 sec.
- FUNCTION Item 8 = OFF delay time = 0.00 sec.