Takara Belmont Luxury MAXIM AB-9500P, Руководство по эксплуатации

Страница: 27 / 32

Before Requesting Repair
25
If any of the problems described below occur, conduct the checks outlined before requesting repair.
Problem Check Points Recovery Procedures
■
Chair does not move.
■
The power switch turns off
when using the service outlet.
■
The amount of current
used is 7 A
(230 V AC) or less.
■
Has there been a short
circuit in one of the devices
connected to the service
outlet?
Overheating Prevention Device
Breaker Function
These are not malfunctions
■
Abnormal sound at startup
7 A or
less?
Is the
switchboard
operating
normally?
Is the
power plug
correctly
inserted?
Is the
power turned
on?
Is there
a short
circuit?
■
Sound when rotating the chair
■
Is the power plug correctly
inserted?
■
Is the power switch turned
on?
■
Has a fuse of the shop's
switchboard or breaker
been tripped?
■
Has the chair been
continuously operated for
an extended period?
■
Correctly insert the power plug. (p. 10)
■
Turn on the power (p. 11).
■
Replace the fuse of the switchboard
or turn on the breaker.
■
The problem is due to the operation
of the overheating prevention device.
⇒
Leave the chair for approximately
10 min. to allow it to return to the
normal condition.
This is a protective circuit that prevents
abnormal overheating of internal
mechanisms due to continuous
operation and similar causes. The
chair might stop moving temporarily.
■
The breaker function operates if the
current used exceeds 7 A (230 V AC).
Use an amount of current that does
not exceed 7 A (230 V AC), and turn
on the power switch again so that the
chair will operate normally. (p. 22)
■
Switch to using a different device and
try turning on the power switch. If the
power cannot be turned on when
using a different device, contact your
closest dealer or Takara Belmont.
This is a protective function that
prevents damage to devices due to
using a current that exceeds the rated
current value.
■
Such sound is due to the internal hydraulic
fluid being cold and is not a functional fault. It
will readily stop.
■
This is the sound of the steel balls rolling
when the chair is rotated. The level of this
sound varies depending on the environment
where the chair is installed.
If any of the problems described above are inspected and the chair does not work normally even after
performing the recovery procedures, immediately stop using the chair, turn off the power, unplug the
power plug, and contact your closest dealer or Takara Belmont.
Click
Snap