Safety Precautions (Must be Obeyed)
4
Power Plug and Cord
Installation/Transport
WARNING
●Do not connect the earth (ground) to the following objects.
• Water pipes
(Complete grounding is not possible as hard plastic pipes are widely used.)
• Gas pipes (Can result in an explosion or fire)
• Lightning rods and telephone dedicated grounding wire (Dangerous during lightning)
●Do not place any objects on top of the power cord.
Damage to the power cord can cause a severed wire or short circuit, resulting in electric
shock or fire.
●Do not plug or unplug with wet hands.
Touching the power plug or outlet with a wet hand can result in electric shock.
●Use a single outlet (do not share an outlet with other plugs).
Be sure to fully insert the power plug into the outlet unitl reaching the base of the plug.
※
110V/120V AC(12A or more),220V/230V/240V AC(7A or more).
Using the same outlet together with the power plug of other devices can result in
abnormal heat generation and possible fire.
●Firmly insert the power plug into the outlet.
Be sure to fully insert the power plug into the outlet until reaching the base of the plug.
Failure to fully insert the plug or similar fault can result in a short circuit or heat
generation that causes a fire.
●Hold by the power plug when unplugging.
Do not pull the cord to remove the power plug from the outlet. Hold by the power plug
at the end of the cord when removing. Removing the plug by pulling the power cord can
damage the power cord, resulting in electric shock or fire.
●Be careful of power cord or plug breakage.
Do not use any power cord or plug that is damaged, or that fits loosely when inserted
into an outlet. Doing so can result in electric shock or fire.
●Securely connect to ground.
Failure to make a ground connection can result in electric shock if there is a malfunction
or short circuit.
Consult an electrician for grounding procedures.
●Unplug the power plug when the chair is not in use.
Turn off the power switch and remove the power plug from the outlet when the chair is
not in use.
Unexpected operation can result in an accident or fire from a short circuit due to
insulation aging.
●Installation precautions
•Installation of this chair must be performed by specialized personnel (personnel from
Takara Belmont or Takara Belmont specified representative).
•The chair must be installed on a perfectly flat and solid floor.
Installing the chair to a location with an angle of 5° or more can result in the chair
tipping over.
