If any of the problems described below occur, conduct the checks outlined before requesting repair.
If the chair does not work normally even after performing the recovery procedures, immediately stop using
the chair, turn off the power, unplug the power plug, and contact your closest dealer or Takara Belmont.
Problem
Check Points
Recovery Procedures
Chair does not move.
Is the power plug fully inserted to
the base of the plug?
Fully insert the power plug into the outlet
until reaching the base of the plug. (p. 13)
Overheating Prevention Device
Breaker Function
Troubleshooting
32
Is the
switchboard
operating
normally?
Is the power
plug correctly
inserted?
Is the power
turned on?
Rated
current
less?
Is there
a short
circuit?
These are not malfunctions
Sound at startup
Sound when rotating the chair
This is the sound of the steel balls rolling when the chair is rotated.
The level of this sound varies depending on the environment where
the chair is installed.
Such movement is due to the internal operating fluid being cold.
Raise the room temperature or continue operating for a short period.
It will recover to the normal condition.
Such sound is due to the internal hydraulic fluid being cold. It is not
a functional fault and should stop shortly thereafter.
The power switch turns off
when using the service
outlet.
Is the power switch turned on?
Has a fuse of the shop's switchboard
or breaker been tripped?
Has the chair been operated for an
extended period continuously?
Is the current being used rated
current or less?
※
12A or less
(110V/120V AC)
※
7A or less
(220V/230V/240V AC)
Has there been a short circuit in
one of the devices connected to
the service outlet?
Turn on the power switch. (p. 13)
Replace the fuse of the switchboard or
turn on the breaker.
Slow movement of the chair
Switch to using a different device and
try turning on the power switch.
If the power cannot be turned on when
using a different device, contact your
closest dealer or Takara Belmont.
This function prevents damage to this
chair if the chair is used when the
allowable current is exceeded.
The breaker function operates if the total
current used by the two outlets exceeds
rated current. Use a current of rated
current or less and turn on the power
switch again.
This is a protective circuit that prevents
abnormal overheating of internal
mechanisms due to continuous operation
and similar causes. The chair might stop
moving temporarily.
The problem is due to the operation
of the overheating prevention device.
⇒
Leave the chair for approximately
10 min. to allow it to return to the
normal condition.
