Takara Belmont Ak-200, Руководство по эксплуатации

Страница: 13 / 20

13
*Operation cannot be started until a mode has been selected.
Once a mode is selected, the mode setting prior to it is stored in memory until the power is turned off.
Mist Level Temperature Level Time Cooling Time
treatment 1
treatment 2
manual
3 3
1 2
4 5
8 minutes 2 minutes
10 minutes 2 minutes
5 minutes 2 minutes
*In the case where the basic settings are to be used when starting changes are not necessary.
Do not change the Temperature setting during warm-up (while the lamp is
blinking on and off).
Changing the Temperature level during warm-up will cause the Temperature level
to go to 0 (Temperature Level lamp in an unlit state) and may result in mist that is
lower in temperature than the set level being generated. In addition, the Temperature
Detection Section may judge that a malfunction has occurred and cause the
display to appear. The same thing may occur when the Temperature Level is raised
during operation when it is at Temperature Level 0. Thus, the operations described
above should not be attempted. In these cases, the display does not indicate a
malfunction. Turn off the power switch and then turn it on again to resume operations.
Close the Upper Cover
Check to make sure that there is no space between the Face Guard
and the customerís head and then slowly close the top cover.
Face Guard Turban
Set this so that the space
from the Face Guard to the
Turban appears uniform.
*Press firmly until both right and
left sides close with a click.
Setting the Operating Mode
Check to see that the Power has been turned on.
1. Select the mode to be used from among treatment1/treatment2/
manual.
3. Press the start/stop key.
2. Change the setting conditions using the Mist, Temperature
and Time keys.
Operation will begin with the conditions that were set.
and (the time set) will go on in turn on the Display Panel and the
Temperature Level lamp will blink on and off.
Automatic operation will begin once the water inside the machine has been heated.
It may take a while for the mist to be generated when the water inside the machine is cold.
Caution