11
Fastening the Face Guard to the Hood
*The side with the crossed strap is the top part and
the side with the strap to be fastened by the ends
is the bottom part.
Resin cord side
Face the side with the seam
to the front when installing.
Align it with the
center of the Hood.
2. Turn on the Power Switch.
Turning on the power switch a few minutes before use
will shorten the time up to the generation of mist.
ON
OFF
Woven Cord Side
2. Attaching the Face Guard to
the inside frame of the Hood.
This installation can be eased by using the 2 tabs
in the upper section of the frame and covering from
top to bottom.
3. Tighten the strap in the bottom
section of the Face Guard.
Adjust the upper section strap (the resin cord side) position so
that it comes to the front edge of the Hood.
Open up the strap in the upper section sufficiently
to accommodate the customerís head.
Turn on the power
1. Insert the power plug in the electrical outlet.
1. Loosen the strap at the bottom
(the woven cord side) of the
Face Guard.
Caution
Do not connect another electrical
appliance to the same outlet.
Push the power plug all the way in to
secure it.
Remove the plug at the end of the
workday or when the steamer will not
be used for a length of time.
