Tajfun RCA 480 JOY, Руководство по эксплуатации

Страница: 13 / 44

13
• Use bolts to connect the firewood processor to the three-point tractor hitch. Fix the bottom
tractor hitch bars with the tension screws to allow the machine to move transversely. During
machine transport observe the total weight of the machine
(See chapter: Specifications ).
• Connect the PTO shaft to the universal joint and secure it by using a safety chain.
• Plug the machine control cable into the 12 V tractor outlet.
Check the length of the PTO shaft upon first installation.
Check the length of the PTO shaft by raising and lowering the machine to determine the position
with the minimum distance between the joints. After PTO shaft installation the length of the pipes
must be shorter for approximately 20 mm.
If the PTO shaft is too long, reduce the length as follows:
• Use a saw to cut both ends of the steel and plastic pipes to the same length. Then file down, clean
and grease the edges.
4. MACHINE SETUP
Model Dimensions Compatibility
PTO Shaft C Line-T 6BR + KK560 1 3/8’’ Z6 – 1 3/8’’ Z6; LKK = 560
EP 12 (RCA 330 JOY, RCA 380, RCA 400 JOY,
RCA 480 JOY)
PTO Shaft C Line-T4 DZ DZ BR + KK510 1 3/8’’ Z6 – 2X; LKK = 510
RCA 330 JOY, RCA 380, RCA 400 JOY,
RCA 480 JOY
When using our machines, we recommend Tajfun PTO Shafts:
The tractor output shaft and machine
input shaft should be positioned as
parallel as possible! Otherwise, the
PTO shaft’s geometry may cause
uneven transmission of the rotation
and subsequent vibrations. If this is not
possible, a PTO shaft with two wide-
angle joints must be used, since this is
the only PTO shaft that ensures a steady
rotation under wide variety of angles.
• PTO shaft (grooved shaft 13/8” Z6 – DIN 9611A) must
comply with the required engine power of the machine
(Specifications).
• The tractor PTO shaft must rotate clockwise. In case
of EP (Electric Power Unit) the shaft must also rotate
clockwise.
• The recommended speed of the PTO shaft:
420 min-¹;
maximum: 430 min-¹; minimum: 400 min-¹.
• When the machine is disconnected place the PTO shaft
into the PTO shaft holder.
Always use a PTO shaft without a clutch.