15-Dec.2017 Ver.1.4
TAIYO YUDEN CO., LTD.
TAIYO YUDEN CO., LTD.
6/9
EBSGJN, EKSGJN
EBAGJN, EKAGJN
MEMO
1) Current measurment
To measure the current, please cut the shorting 1pin and 2 pin of CN6. And connect an
ampere-meter between the pins of connector CN6 to monitor the current directly.
2) About the power supply of the module
When you use external power supply, please supply power from 9pin and 10pin of CN3.
On this configuration, you cut short circuit 1pin and 2pin of CN5 and should separate
3V3OUT of FT232RQ.
3) USB to serial UART interface
It needs to install driver of FT232RQ to use USB for UART interface.
The drivers are available on FTDI website.
http://www.ftdichip.com/Drivers/D2XX.htm
In addition, by the application development, please assign GPIO as follows.
GPIO
UART
P0.00
RTS
P0.01
TX
P0.02
CTS
P0.03
RX
CN5
CN3
9
2
CN6
2
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
