Taiwei TW-510A, Руководство пользователя

Страница: 6 / 19

5. The operation order of machine
5.1 Place the materials need cutting on the plastic backing plate of the workbench.
5.2 Place the knife die on the position of the materials need cutting.
5.3 Move the rocker arm at the upright top position of the knife die.
5.4 Press the descending button of the rocker arm with hands.
5.5 Release the descending button of rocker arm to move rocker arm. Remove the required
cutting materials. One cycle of operation is completed.
5.6 Place the knife die on the materials need cutting again to enter next cutting operation.
Note: Press the OFF button of motor when people leave machine or repair it.
6. The maintenance and service of machine
6.1 The cleaning work of machine
The routine cleaning work of machine shall be carried out once per shift, and the overall
cleaning work shall be carried out once per week. The oil filter must be cleaned once per
month.
Suggestion: Raise the main post to the maximum position and clean it. Blow off pollutants
from inside to outside with compressed air during cleaning of oil filter.
6.2 Hydraulic oil level
It is necessary to check the oil level in machine body in application of machine. If it is lower
than the minimum position, the hydraulic oil of the same type shall be supplemented. If there
is severe loss, please find out the reason and take corresponding measurements.
After cumulative 2000 hours or at most no more than 1 year of working time, the hydraulic oil
shall be replaced.
Suggestion: When clean the oil tank just after the machine stops, do not wipe it with wool
yarn.
6.3 The overflow valve, which has been set before leaving factory and locked, can not been
adjusted randomly so as to avoid the machine being damaged due to overload.
6.4 In the material cutting process, any position of plastic backing plate shall be used evenly
and can be rotated 180°in horizontal plane.
5