© 2015 SmokerStore GmbH
Page: 26
EVERY situation accurately! Unfortunately, there is no watertight switch
in this design size, too!
Fact is: Liquid can most easily enter into the battery carrier through
the button!
Simplest solution: Do not allow liquid to enter!
CLEANING
In case of liquid has entered the device, proceed as follows (WITHOUT
WARRANTIES):
1. Remove the battery IMMEDIATELY and leave the battery compart-
ment open.
2. Unscrew the evaporator.
3. With the open battery compartment downwards shake the device
to get the liquid out of it as far as possible (depending on the quan-
tity maybe outdoors!).
4. Rinse the device with warm, clean tap water directly into the batte-
ry carrier shaft and onto the circuit board.
5. Again step 3.
6. Flood the interior again with distilled water to prevent causing cal-
cium deposits (available e.g. for car batteries and irons).
7. Again step 3.
8. Dry the device extensively WITHOUT battery, battery cover and eva-
porator e.g. in the oven at max. 60°C for at least two, or better three
hours. Open the oven from time to time, so that the moisture can
escape. Press the button in between (CAUTION HOT!). Alternatively,
you can dry the device on the powered, warm heating over night.
9. Mount the device again, first the evaporator and finally the battery.
In our tests it worked again then EVERY TIME without any problems
– thanks to our new button! Please don’t try this approach with a
conventional push-button! Generally, you won‘t get the liquid out of
a classic miniature push-button housing by this procedure.
Taifun Vireo
Operation manual
