Taiden HCL-404, Инструкция по установке и эксплуатации

Страница: 13 / 78

5
2.6 Installation
1. Swivel (pan) wall bracket (standard)
Loudspeaker-mount section Assembled bracket Wall-mount section
The bracket is shipped after being assembled by default, so the bracket you receive is one piece. After removing the nut and
screw at the fixed point, as well as the movable stud and buckle, the bracket is decomposed into two parts as shown in the
figure below, the left section is installed on the back of the sound column. The right section is installed on the wall using
standard screws, as shown in the figure below.

Swivel angle adjustment: remove the cover, use a tool to loosen the nut, rotate it left and right to an appropriate angle,
tighten the nut after adjustment, and reinstall the cap.
Loudspeaker-mount section Wall-mount section
2. Bracket wall mounting for HCL-804A
1) Remove the nut and screw of the fixed point of the bracket, as well as the movable studs and buckles;
2) Remove the screws on the back of the column loudspeaker (details for section 2.4), install the loudspeaker-mount section on
the back of the column loudspeaker, and use the original screws to lock the loudspeaker-mount section and the column
loudspeaker;
3) Install the wall-mount section using the standard screws;
4) Connect the audio cable;
5) Pull up the column loudspeaker, reassemble the loudspeaker-mount section and wall-mount section, and set the required
swivel angle.