TagMaster XT Mini, Руководство пользователя

Страница: 24 / 32

XT-1/XT Mini Manual 13-111 05, 2015-08-14
Page 24 of 32
5 Connecting to an External System
The following sections describe how to connect the reader to another system. Note that the reader requires
more power than a typical proximity reader and should have its own power supply.
Wiegand/Magstripe
The reader can be connected to a typical access control system using Wiegand/Magstripe. The access
control system can control the reader's LED indicator using inputs IN1 and IN2. Input IN3 can be connected
to a presence detector such as an inductive loop. An overview is shown in Figure 21.
Figure 21 Reader connected to access control system using Wiegand/Magstripe
For common access control systems, the reader can be configured using DIP switches as described in
section 5.1.1, "Easy Configuration", below. For other systems, all Wiegand/Magstripe settings are available
under Settings…/Interfaces…/Wieg/Mag in the web interface.
5.1.1 Easy Configuration
The reader can be configured to work with common access control systems using DIP switches S101:6-8.
When any of these switches are in the ON position, the reader is configured to report tags once, accept
SecureMarkID tags only, and use the specified Wiegand/Magstripe format.
The following sections describe how to connect the reader to different access control systems and how to
set the reader's DIP switches. The following format is used to describe cable connections:
[READER SIGNAL]
[ACCESS CONTROL SYSTEM SIGNAL]
5.1.1.1
ASSA ARX/RX WEB (with 500RW22)
Configure the ARX/RX WEB system to use card type Wiegand.
GND 0V IN1+ 12V
CL/LOAD N/C IN1- LED_GREEN
D0/CLK D0 IN2+ 12V
D1/DATA D1 IN2- LED_RED
S101 - Wiegand format: W34N S301 - Vigilant pull-ups disabled
Tested version: RX WEB PR300233 build-8418 version-17.2.0.5
GND
CL/LOAD
D0/CLK
D1/DATA
IN1+
IN1-
IN2+
IN2-
Wiegand/Magstripe
Green LED
Red LED
IN3+
IN3-
Presence loop
V
ig
il
a
n
t
R
e
a
d
e
r
Access Control
System
Loop Controller
1 8
ON
S101
1 8
ON
S301