Operation
1.
Make sure your audio sources (amplifiers, receivers etc.) are switched off.
2. Make sure that the volume regulators on your audio sources are set to minimum.
3. Make sure that the Volume Regulators on your Speaker Selector are set to
minimum.
4. Switch OFF all Zones on the Speaker Selector (Zone Selectors switched in the top
position).
5. Using speaker cables (not supplied with this product) connect your audio source.
If you connect one amplifier connect it to the Input A located on the rear panel of
the Speaker Selector. If you want to use one more amplifier as an audio source
connect it to the Input B.
6. Using speaker cables (not supplied with this product) connect your speakers to
required Speaker Output to Zones terminal connectors (Output) located on the
rear panel of the Speaker Selector.
7. Switch on your audio sources and start playback on connected devices.
8. Select desired Zones (press down corresponding Zone Selector ON/OFF swiches)
where to you want to transmit an audio signal from one of your audio sources.
9.
For each Zone you can can select one of 2 sources (Input A or B) using Source
Amplifier Selector (A/B) corresponding to each zone. Press the switch down to use
the audio source connected to the Input A, press again to use the audio source
connected to the Input B.
10. Set the sound volume level on your audio sources and regulate the volume for a
selected zone using Volume Regulators corresponding to each zone. The ma-
ximum level of sound volume will be determined by the level set on your audio
sources.
Note!
High volume levels can damage your amplifier(receiver), this product or
speakers. This may void your warranty.
Note!
Avoid to short-circuit of cables – it can damage your amplifier(receiver), this
product or speakers. This may void your warranty.
Zone Selectors:
ON: Press down of these switches (the switch in the down position) to transmit an
audio signal from your audio source (amplifier, receiver etc.) to speakers in the
corresponding zone.
OFF: Press it again to switch off the transmission (the switch in the top position).
Source Amplifier Selectors:
A: Press down of these switches (the switch in the down position) to transmit an audio
signal from the audio source (amplifier, receiver etc.) connected to the Input A to
speakers in the corresponding zone.
B: Press it again (the switch in the top position) to choose the transmission from the
audio source (amplifier, receiver etc.) connected to the Input B.
Volume Regulators:
Each zone has an independent Volume Regulator. You can adjust the sound volume of
each zone from minimum (the knob – max counter-clockwise) to maximum (the knob
– max clockwise). The maximum is the sound level which is set on the audio source
(amplifiers, receivers etc.) selected for the given zone (Zone Selectors).
10
