Taga Harmony PC Series, Инструкция по эксплуатации

Страница: 7 / 12

7
1. Phase Detection
A. Make sure that the Polarity Switch is set as 1 (default). It means that the female
contacts in the Power Sockets have polarity according to the L and N marking on
the top panel of the conditioner.
B. Without connecting any external equipment plug the Power Cable to the
conditioner and into the electrical outlet.
C. The Phase Indicator WILL ILLUMINATE when the phase is INCORRECT.
If the phase is incorrect then:
d1- Remove the Power Cable from the electrical outlet;
d2- Set the Polarity Switch to 2;
d3- Connect the Power Cable to the electrical outlet;
d4- The Phase Indicator should not be illuminated - it means that the phase is
correct.
D. If your audio-video equipment has the polarity marking (L/N) make sure to connect
correctly the equipment power cable plug to the power line conditioner according
to the polarity marking.
Hooking Up the Conditioner and Operation
The Phase Detection is not related to the Power Switch and is always
active when the conditioner is connected to the electrical outlet.
TOP
9. Switched Power Sockets
Group I recommended for digital equipment.
Group II recommended for sound sources.
10. Unswitched Power Sockets
Group III recommended for preamplifiers / accessories.
Group IV recommended for amplifiers.
Never operate this switch when the conditioner is connected to the
electrical outlet – this may damage the conditioner and/or connected
devices – this may void your warranty.
Make sure to disconnect the Power Cable before operating the Polarity
Switch!
Setting the Polarity Switch to 2 will exchange the polarity in the Power
Sockets of the conditioner (L → N and N → L).
Make sure to consider this when connecting the external equipment.