You can change the way your CD20R displays information.
The controls for this are only on the remote control.
Press the
time
button repeatedly, or press and hold, to cycle
through the time display modes.
1 - The display shows the amount of time played so far on the
current track. The word
TIME
is also displayed.
2 - The display shows the amount of time remaining on the
current track. The words
TIME REM
are also displayed.
3 - The display shows the amount of time remaining on the CD.
The words
TOTAL TIME REM
are also displayed.
4 - The display shows the amount of time played so far on the
CD. The words
TOTAL TIME
are also displayed.
While a CD is playing, you can display the table of contents by
holding down the
toc
button. This consists of the total number of
tracks and playing time of the CD.
Press the
display
button to switch the display off and on.
Programming allows you to play tracks in the sequence you
choose instead of the order in which they appear on the CD.
To do this, you have to enter your chosen sequence of tracks
into the memory of the CD20R. When you store a program,
you assign a track to each step of the program. This process is
called programming and the sequence of steps is the program.
This section describes how to store and play a program. All the
buttons referred to can be found on both the front panel and the
remote control.
In order to store and play a program, your CD20R has to be
in program mode. In program mode, the CD20R plays in step
sequence instead of the recorded track sequence.
To enter program mode, press the
stop
button for at least two
seconds. The display will show:
PROGRAM
TRACK
with the track number above it
STEP
with the step number below it
TOTAL TIME
with the time above it
entering
program mode
time display
table of
contents
display
display off
18
19
display options
programming
stop
hold for at least
two seconds
GRA00046.1-[CA]CD20R 13/03/01 09:37 Page 19
