TAD TAD-C2000, Руководство пользователя

Страница: 10 / 112

10
BALANCED BALANCED
USB
XLR COAXIAL
AC IN
12 V TRIGGER
IN
1 2 3
4 5
DIGITAL INPUT
BALANCED
1. GROUND 2. HOT(+) 3. COLD(-)
OUTPUT 12 V
TOTAL 125 mA MAX
R L
LINE 1 BALANCED LINE 2 LINE 4 LINE 3 LINE 1 BALANCED LINE 2 LINE 4 LINE 3
D2
D3
D1
ANALOG INPUT ANALOG OUTPUT
BALANCED
1. GROUND 2. HOT(+) 3. COLD(-)
ANALOG INPUT ANALOG OUTPUT
OUT
Rear panel
17 19 16
12 13 15 14
18
ANALOG INPUT R connectors 12
Select either balanced (XLR-3-31) or unbalanced (RCA pin jack)
connectors in accordance with the type of connectors on the
component to be connected.
ANALOG OUTPUT R connectors 13
Select either balanced (XLR-3-32) or unbalanced (RCA pin jack)
connectors in accordance with the type of connectors on the
power amplifier to be connected.
ANALOG INPUT L connectors 14
Select either balanced (XLR-3-31) or unbalanced (RCA pin jack)
connectors in accordance with the type of connectors on the
component to be connected.
ANALOG OUTPUT L connectors 15
Select either balanced (XLR-3-32) or unbalanced (RCA pin jack)
connectors in accordance with the type of connectors on the
power amplifier to be connected.
DIGITAL INPUT connectors 16
Select either USB, COAXIAL, or XLR in accordance with the
type of connectors on the component to be connected.
12 V TRIGGER IN connector 17
When an external component with a 12 V TRIGGER connector is
connected, this unit’s ON/Standby power state can be changed
by operation of the power control on the external component.
Connector: Ø 3.5 mm monaural mini-jack
Operating conditions:
During power Standby mode, when input signal’s voltage
changes from L to H ................................. Power switches to ON.
During power ON mode, when input signal’s voltage changes
from H to L ........................................ Power switches to Standby.
When an H signal is being input to the 12 V TRIGGER IN
connector, the unit’s power switch cannot be used to change to
Standby mode.
12 V TRIGGER OUT connectors 18
When an external component with a 12 V TRIGGER connector
is connected, operating this unit’s power switch will change
the external component’s power state (ON/Standby).
Connector: Ø 3.5 mm monaural mini-jack
Operating conditions:
When this unit is in power ON mode, an H signal is output.
When this unit is in power Standby mode, a L signal is output.
When linked to other components with 12 V TRIGGER input
connectors, a total of five connectors and maximum 125 mA
can be output. Output exceeding 125 mA is not possible, so
take care to avoid excessive current.
AC IN connector 19
Connect the accessory power cord here.