-9-
External connection for 0-10V DC / PWM signal
WARNING: If there is a need to make external connection (PLC / Pump Controller) it is mandatory to perform the following operations.
1. Remove the 4 screws (1) to open the upper shell (2).
2. Remove the cap (3) for external signal wiring.
3. Disconnect the connector (4) from control board (5).
4. Insert the cable (6) into the cable gland M12x1.5 (7)
and screw it to the cover.
5. Strip the wires (5 mmMIN,) and insert them into the
connector (4), then secure them with the screws (8).
6. Re-connect the connector (4) to the electronic board,
close the cover and secure it with the screws
Figure 8 - External connection for 0-10V DC / PWM signal
Step 1
Step 4
Step 2
Step 5
Step 3
Step 6
