Steps To Jump Start Vehicles(12V Only)
1. Plug the blue end of Smart Jumper Cable into the 12V Jumper Cable
Interface on the unit
2. Connect the clamps to the vehicle battery. Red clamp to positive
po), black clamp to negative polarity(-)
3. Operate according to the sate of the safety indicator
4.
Go to your car and turn the ignition to start position
5.
Remove the Smart Jumper Cable after cranking your car successfully
The indicator is steady
green.
The: connection is right, and
it’s ready for jumping start.
The indicator is steady red,
and there is buzzing:
The positive and negative
poles are reversed. Please
reconnect and wait until the
indicator turns to steady
green.
The indicator flashes in
green, and there is
buzzing.
The vehicle battery is at low
voltage. You need to press
the ”BOOST” button on the
Smart Jumper Cable and
wait until the green light
becomes steady, then start
your car within 30 seconds.
The indicator does not
light, and there is no
buzzing.
The vehicle battery may be
totally dead. Please make
sure the connection is right.
After that, press the
“BOOST” button on the
Smart Jumper Cable and wait
until the indicator becomes
steady green, then go to start
your car within 30 seconds.
