Chapter 04:
Upgrading Your Sahara Slate PC
memory module. Be sure to follow the procedures
in the preceding section,
Before you Begin
ANY Upgrade Procedure
.
1.
Turn off your computer, turn it
over and place it face down on
a solid, flat surface. Be careful
not to place it on something
rough that could damage the
display screen.
2.
Locate the RAM module
compartment near the center of
the back panel of the system.
Loosen the two screws that
secure the RAM module
compartment cover.
3.
Lift the cover from the edge
where the screw holes are located
to remove it and set it aside. Inside is
the RAM slot. Depending upon
your system’s configuration, it
will either be empty or
populated with an existing
module.
4.
If it is empty, proceed to step 6,
otherwise, using your fingers or a
small screwdriver, press the two
plastic tabs on the sides of the RAM
module away from the module.
The top edge of the RAM
module should pop up slightly.
5.
Gently pull out the RAM module
as shown in the illustration.
Содержание Sahara Slate PC i412T
