Tableau TD2u, Руководство пользователя

Страница: 29 / 71

7. Turn on the TD2u by pressing the TD2u power switch located on the front of the unit to
the lower left. The green Power LED indicates that the duplicator is turned on.
Note: When connecting an IDE source disk to the TD2u, always connect the blue
end of the IDE cable (TC6-2 or TC6-8) to the TD2u and the black end to the hard
disk. If using other than a Tableau-supplied cable, ensure that the colored stripe on
the cable aligns with Pin #1 on the hard disk. Failure to do so can result in unreliable
communication between the hard disk and the TD2u.
You can connect two destination SATA disks to the TD2u. The TD2u can write to two
destination drives simultaneously. To create a single copy, connect a drive to either the Dest-1
or USB destination port.
Drive Detection
After initialization, the TD2u begins drive detection.
Steady illumination of the IDE, SATA, USB Source, Destination 1, Destination 2, and USB
Destination LEDs indicates drive detection. A blinking LED indicates that detection is still in
progress.
Note: Note: Because IDE drives do not support hot plug, they must be plugged in
before the TD2u is turned on in order to be detected. Unplugging an IDE drive that
has been detected by the TD2u will cause erratic or unexpected behavior since
there is no way for the TD2u to know that the IDE is no longer connected.
CHAPTER 2 Setting up the TD2u 29