SERVICE MANUAL
T3MOTION PROPRIETARY INFORMATION
Use or disclosure of data contained on this sheet is
subject to the restriction on the cover or title page of this
document.
Document No
040-00068
Revision
1
Sheet
9
6.1
After removing the nylock nuts, washers and grommets from the four studs, lift
the board out. You may have to use a screwdriver to help lift it off the studs.
7.1
Install the new P/S light board. Carefully align it on the four studs as shown.
7.2
Place a grommet, then a washer, then a nylock nut on each stud and snug them
down with the nut driver.
Be sure to leave the
grommets under the board
on the studs.
Nylock nut
Washer
Grommet
