ROW weighing scales operation manual
REV: C1, June 2015
ROW weighing scales operation manual
accumulation function is not automatic.
Secondary function (
C or
) , is to act as a clear key or to
move active digits left when setting values for parameters or other
functions.
UNIT or U
Press this key to select the weight unit.
Secondary function (ESC) , is to return to normal operation when
the scale is in a parameter setting mode.
ON/ OFF
Turn on or off the power.
3. BASIC OPERATION
3.1 Zeroing The Display
You can press the
ZERO
key at any time to set the zero point from
which all other weighing and counting is measured, within 4% of power
up zero. This will usually only be necessary when the platform is empty.
When the zero point is obtained the display will show the indicator for
zero.
The scale has an automatic rezeroing function to account for minor
drifting or accumulation of material on the platform. However you may
need to press the
ZERO
key to rezero the scale if small amounts of
weight are shown when the platform is empty.
3.2 Taring
Zero the scale by pressing the
ZERO
key if necessary. The zero
indicator will be on.
Place a container on the platform, a value for its weight will be
displayed.
-2-
by using the keys
PRINT/M+
,
G/N
,
TARE
to select the required setting.
Enter the selected setting by pressing
ZERO
, display will be
shown ”
load
”.
Load the calibration mass weight on the platform and wait few
seconds for display stability.
After the stable indicator on press
ZERO
, display will be
shown ”
pass
”.
After the calibration the display will start a self test. Remove the load
from platform during the test. Display will come to weighing mode
automatically.
If display will be shown any error or incorrect value, repeat the
procedure again.
8. BATTERY OPERATION
The weighing scale can be operated from the battery if desired. The
battery life is approximately 35 hours.
When the battery needs charging, the battery symbol will blank. The
scale will still operate for about 1 hours after which it will automatically
switch off to protect the battery.
To charge the battery simply plug into the AC adapter. The scale
does not need to be turned on.
The battery should be charged for 12 hours for full capacity.
In the LCD display has an battery indicator to indicate the status of
battery charging. When the scale is plugged into AC adapter, the
internal battery will be charged. When turn on the indicator, if the
battery indicator is full then the battery has a full charge. If it is half
then the battery is nearly discharged and empty indicates the battery
should be charged. When charge the battery, the indicator will be flicker.
As the battery is used it may fail to hold a full charge. If the battery
life becomes unacceptable then contact your distributor.
-7-
Содержание ROW Series
Страница 1: ...ROW Weighing Scales...
