The signal wire and power board switch
pass into the vehicle through the hole
Controller
Tundra
pass into the vehicle through the hole.
Electric
Installation by
Magnetic Control
1. Pull out the fuse and connect
th b tt
i
4.Connect white and brown signal wire with wired magnetic
induction module .
5. Insert back the fuse and sort
t th
i
the battery wire.
Battery
Power board
switch
out the wires.
3. Connect motor wire and LED lamp wire.
2. Connect the control wire and arrange all function wires to the pointed positions.
Chassis on the right
（
The instruction is mentioned for the LED type. The installation for the basic type is basically similar to LED type
，
but the only difference is without LED lamp.
）
Step 1: Find out the control input wire and pull out the fuse (ensuring
i
it f t d i
i t ll ti )
d
t th
iti
d
circuit safety during installation) and connect the positive and
negative pole of wire harness to vehicle battery respectively.
Note: Battery wire can not be modified privately.
13
www.tmax.biz
