Tundra
The installation of the right side for motor linkage and
The installation of the right side for motor linkage and
board is referenced to the left side.
Step 5: Install the board and adjust
the T- nut to make the two end faces
of the board reach to an appropriate
Socket Cap Screw M6
×
25
of the board reach to an appropriate
position. Then use M6
×
25 socket
cap screws for connecting and
tightening (Tighten torque is12Nm).
11
Note
：
If the gap between board and vehicle t2 is larger than t1,the motor linkage should be adjusted.
www.tmax.biz
