T.J. FRAZIER AGRIBUGGY 5D, Инструкция оператора

Страница: 23 / 37

Water pump drive belt.
1. Slacken the idler pulley mounting and adjusting
bolts (Fig. b1).
2. Move idler pulley to obtain the specified belt
tension, then tighten the adjusting and mounting
bolts.
3. Re-check tension.
Air conditioning compressor drive belt
(if fitted).
1. slacken the centre retaining bolt on the jockey
pulley eccentric.
2. Rotate the eccentric to tension the belt.
3. Retighten the centre bolt.
NB - Do not overtighten the belt.
Hydraulic pump drive.
The hydraulic pump is driven by a propeller shaft
connected to the front engine crankshaft pulley.
This shaft should be greased weekly or every 50
operating hours. There are 3 grease nipples on the
shaft - one on each universal joint and one on the
centre sliding section.
One end of this shaft will have to be removed to
replace any of the drive belts. It is recommended,
and is in fact easier, to
disconnect this from the
hydraulic pump end.
Take care not to pull the two shaft halves apart - If
you do so it must be put back together in exactly the
same position to ensure it stays in balance.
Maintenance
Fig. b1 - Water pump drive belt.
1. Idler pulley.
2. Idler pulley adjusting bolt.
3. Idler pulley mounting bolt.
4. Water pump pulley.
Hydraulic pump
drive shaft Air conditioning
compressor jockey
pulley eccentric
23