T.J. FRAZIER AGRIBUGGY 5D, Инструкция оператора

Страница: 11 / 37

6/ Hours worked
Press this button to display the accumulated time (in hours) worked in the LH display window. It can be
reset to zero whenever required (see below).
7/ Reset
Area, distance and hours worked can be individually reset to zero at any time. To do so, firstly select the
function that you wish to reset and then press and hold down the reset button. The display will flash for a
few seconds and will then revert to zero.
8/ Metric / Imperial
The ICM can convert any displayed or stored information between Metric and Imperial units at any time.
A small chevron indicator at the bottom of the RH display indicates which units are currently selected. To
convert from one to the other, simply press the Metric/Imperial button to move the chevron between the
MET & IMP indices below the display window.
9/ Fuel level
The LH side of the RH display operates like a conventional fuel gauge. Should the fuel level drop to
around 10 litres the indicator bar will flash and an audible alarm will sound every 10 seconds.
10/ Ground speed
The forward speed is permanently displayed in the RH display in either mph or kmph
Ground speed alarm
Should the maximum recommended forward speed (normally 30 mph) be exceeded the forward speed
display will flash and the audible alarm will sound.
Four wheel steer alarm (if fitted)
The ICM provides an output for the electronic 4WS control. This activates at speeds above 12 mph. If the
4WS is not switched into "Road mode" when this speed is reached an audible alarm sounds in the 4WS
control box and a visual warning illuminates.
11/ Temperature gauge
The temperature display in the RH window works like a conventional gauge. There is also a two stage
warning system built into the system to indicate engine overheating. At the first stage, when the indicator
goes into the red sector, the indicator bar will flash and the audible alarm will sound. If the engine
continues to get hotter the audible alarm volume will increase and "STOP" will flash in the LH display. The
engine must be stopped when either of the alarms sound to avoid damage and the cause of overheating
be investigated immediately.
12/ Clock
Press this button to display the time of day in the LH window
13/ Area override
Press this button to override the automatic cutout on the area meter. When you do so the area/distance
meters will stop recording, the chevron in the LH display will flash and the L.E.D will illuminate on the
override button. This can also be used if an automatic cut-out is not fitted to the sprayer/spreader
controls.
Operating - ICM
11