T.J. FRAZIER AGRIBUGGY 5D, Инструкция оператора

Страница: 20 / 37

Seed Drilling
Safety
Only seed drill conversions supplied or recommended by T.J. Frazier Ltd. should be fitted to the
Agribuggy 5D. Incorrectly fitted drill units will invalidate the manufacturer's warranty, may be hazardous
to the operator and may seriously reduce the life of the machine or some of its major components.
The only drills currently suitable for fitting to the Agribuggy are those of the pneumatic type with
lightweight, Suffolk coulter toolbars up to a maximum width of 4 metres.
Make sure you follow the safety, operating and maintenance instructions given by the respective drill
manufacturer.
Operation
When drilling with the Agribuggy, a PTO speed of 520 rpm is normally more than adequate to operate
this type of airseeder.
Whilst drilling the engine speed should not exceed 3200 rpm and ideally should be kept below 3000 rpm.
Wheel track eradicators should be set as shallow as possible to keep the draft load on the Agribuggy to a
minimum and following harrows should only be fitted to 3m units.
Maintenance
An oil-to-air hydraulic cooler unit must be fitted in front of the engine radiator when driving a pneumatic
airseeder. This should be kept perfectly clean together with the radiator immediately behind it. Failure to
do so will result in overheating of both the hydraulic and engine cooling systems.
Service & Warranty.
The Agribuggy carries a 12 month / 500 hour warranty on defective parts and workmanship. It does not
cover faults caused by incorrect use and servicing or faults caused by fertiliser or chemical corrosion.
All servicing should be carried out as per this instruction manual during the warranty period. The first
service is normally carried out by the customer after the first fifty hours running. If any faults are
apparent on delivery, at this first service or during the warranty period we would be grateful if you would
notify us as soon as possible even if the fault is rectified by yourselves. We have found many people
repair straight-forward faults themselves without telling us, however our policy is one of continual
improvement and with your co-operation together with any suggestions and ideas we shall continue to
improve the machine to our mutual advantage.
If any problems occur with the machine please contact your supplier, without delay, with whom you can
discuss the best way to deal with the problem to avoid unnecessary delays. If a repair is carried out by
yourselves or by an outside engineer to save time, and you wish to claim costs under warranty,
we must
be notified first or the claim will not be accepted under any circumstances.
Unauthorised repairs
may affect or even invalidate any remaining warranty. Any parts replaced must be returned to us for
assessment.
If our service engineers are called out at any time , to work on the machine or if the machine has
to be returned to our works for repair, it must be thoroughly cleaned to remove all chemical and
fertiliser residues to enable the work to be carried out safely and effectively. If the machine is not
clean , we reserve the right to either refuse to carry out the work or to charge for cleaning.
Service & Warranty
20