Translation of the Original Operating Instructions
5
Each time the pump is put into operation, please make sure that the pump is set up securely and firmly standing.
The unit must always be positioned upright on an even surface.
Please inspect the pump visually prior to each use. This applies in particular to the mains connection line and the
mains plug. Make sure that all screws are firmly tightened, and verify the perfect condition of all connections. A
damaged pump must not be used. In any case of damage, the pump has to be inspected by qualified service
staff.
Prior to the first time the pump is put into operation, the pump housing (8) has to be fully
vented. To do so, please fill the pump housing (8) completely with water. To do this, open the
cover of the filter housing (19) and fill the pump housing incl. filter housing (18) completely with
water through this opening. Fill the pump housing (8) with water to the maximum possible level.
Please check to make sure that no leakage occurs. Subsequently, close the filling opening
airtight again. It is highly recommended to vent the suction line (2) as well, i.e. to fill it with water.
It is true that the electrical pumps of the T.I.P. SmartGarden series are self-priming and can be
put into operation by filling only the pump housing with water. In this case, however, the pump will
require some time before it will have sucked in the liquid to be pumped and proceed to the actual
discharging function. In addition, this way of proceeding may require the pump to be filled several times. This
depends on the length and diameter of the suction line. After filling, please open any shutting device (7) in the
pressure line, for instance a water tap, to enable the air to escape during sucking in.
Plug the mains plug into a 230V AC socket. Subsequently, please start the pump by operating the on/off switch.
As soon as the liquid is being discharged evenly and without air mixture, the system is ready for operation. To
stop the pump, please operate the on/off switch again. You may then close the shut-off valve in the pressure line
again.
If the pump was out of operation for some extended period of time, the steps described above have to be
repeated for a renewed putting into operation.
The electrical pumps of the T.I.P. SmartGarden series are equipped with an integrated thermal motor protection
feature. In the case of overload, the motor will switch off independently and on again after cooling down. For
possible causes and their elimination, please refer to the “Maintenance and troubleshooting” section.
8. Automation via wifi app and status display explanation
8.1.
Display structure:
8.2.
Light status display
Light status icon
Gradual change
Fast flash
Normal light
Light off
Slow flash
8.3.
Start up the pump:
Lightning as follow, before/after plug into power supply, and press the
“On/Off” button of the pump.
Abb.1
1.
2.
1. Display 1:
T.I.P. logo
➢
Indicates current status via different
light signals.
2. Display 2:
Operating light
➢
Red light indicates connection to the
power supply. No further function.
17
