through RDS radio text, RDS programme type, frequency and today’s date.
•
If no RDS information is available, the currently tuned frequency is shown.
8.3
Settings
Scan settings
By default, FM scans stop at any available station. This may result in a poor signal-to-
noise ratio (hiss) from weak stations. To change the scan settings to stop only at stations
with good signal strength, select Menu >
Scan setting > Strong stations only?
>
Yes
.
Audio settings
By default, all stereo stations are reproduced in stereo. For weak stations, this may
result in a poor signal-to-noise ratio (hiss). To play weak stations in mono, select
Menu >
Audio setting > FM weak reception: Listen in mono only
>
Yes
.
9
Aux in mode
Aux in mode plays audio from an external source such
as an MP3 player.
To play audio with Aux in mode,
1. Turn the volume low on both the unit and, if
adjustable, the audio source device.
2. Connect the external audio source to the Aux In
3.5 mm stereo socket.
3. Either press Mode until the display shows
AUX in
or select Menu >
Main menu > AUX in
.
4. Adjust the volume of the unit (and, if necessary, the audio source device) as
required.
10
Alarms and sleep
As well as a clock/calendar, there are two versatile
wake-up alarms with snooze facility, and a sleep
function to turn the system off after a set period. Each
alarm can be set to start in a particular mode.
To set the clock/calendar, see
Getting started/setup
.
10.1
Alarms
To set or change an alarm, either press Alarm or
select Menu >
Main menu > Alarms
.
Select the alarm number (1 or 2) then configure the
following parameters:
•
Enable
: on/off,
•
Frequency
: Daily, Once, Weekends or
Weekdays,
•
Time,
•
Mode
: Buzzer, Internet radio, DAB, FM
