T+A V10, Руководство пользователя

Страница: 34 / 44

Back panel connections
1 1 1 1
AUX/PH input sockets
Universal pre-amplifier input
A
B
G10 turntable with an integral phono pre-amplifier
can be connected to this input.
Other turntables can be connected using the B
PH2000 phono pre-amplifier, which is available as an
optional accessory.
2 2 2 2
AUX - input sockets
Universal pre-amplifier input.
3 3 3 3
TUNER - input sockets
Input sockets for connecting high-level signal sources such
as tuner.
4 4 4 4
DISC - input sockets
Input sockets for connecting a disc player (CD, DVD or
SACD player).
5
5 5
5
RECORDER
Input and output sockets for connecting a device which
can record and play back (tape, CDR recorder etc.).
6 6 6 6
    R,     L
( loudspeaker terminals )
Loudspeakers of 4 or 8 Ohm impedance (DIN values)
can be connected to these terminals. The change-over
switch
7 7 7 7 must be set to match the impedance of the
loudspeakers.
Note:
If the loudspeakers are to be used in countries outside
the EU the red/black stoppers can be removed from the
loudspeaker terminals. The speakers can then be
connected using banana plugs.
The stoppers are simply a push-fit in the terminals, and
can be prised out from the rear using a suitable tool
such as a knife blade.
7 7 7 7
4 Ohm / 8 Ohm change-over switch
Change-over switch for loudspeaker load impedance.
CAUTION:
To avoid overloading the amplifier it is essential to
set this switch to the actual impedance value of
your loudspeakers!
Note:
The impedance of your loudspeakers is stated on the
back panel placard or in the Specification in the
instruction manual provided with them.
8 8 8 8
PHONES
(headphone socket)
Socket for stereo headphones with an impedance of at
least 50 Ohm.
9
9 9
9
R
LINK
Control output for

devices with R
LINK
inputs.
0 0 0 0
Mains fuse
A replacement fuse should only be fitted by a qualified
person. The replacement fuse must be of exactly the
same type and rating as the original, as stated on the
amplifier’s back panel placard.
±
± ±
±
Mains input / mains switch
This socket is for mains connection and contains the main
fuse.
The primary mains switch is used to isolate the
machine completely from the mains supply.
To operate the amplifier the primary mains switch
must be moved to the '1' position.
For correct connection refer to the sections
' INSTALLATION AND WIRING ' and ' SAFETY NOTES ' .
34