T+A M Active, Руководство пользователя

Страница: 13 / 16

13
Using the automatic
power-on circuit The  loudspeakers are fitted with an automatic power-on circuit which
turns the speakers on from stand-by mode when a music signal is present, and
turns them off again about ten minutes after the music has ended.
The automatic power-on circuit can only work if the mains switch on the back
panel is at the ON position (position 1).

 

The power consumption of the loudspeakers in stand-by mode is very low (less
than 1 Watt).
If you know you will not be using the speakers for a long period, disconnect
them completely from the main supply.
If your pre-amplifier features switched mains outputs, the speakers can also be
connected to them and operated in this way.
Use with the
 
If you connect the speakers to a 

Multi-Source System, then the

can be switched on by a trigger signal from the

. In this case
the loudspeakers are always switched on with the

– not just when the
music starts. This eliminates the possibility of “swallowing” the initial beats of
the music.
Necessary settings in the 'System Configuration menu' of

Please select the following settings in the System Configuration / Loudspeaker
menu of the

‘s:
Switching voltage: On
Loudspeaker: External
(
 as L/R speakers,

as Centre)
External (only

,

is muted)
(for details see the

operating instructions)